Vintage CC472 Double Offset Bath Supply, Polished Brass

This is a nice set of tubes. The were a great starting point for my needs. For my specific application I needed to add a 4.5" offset to both tubes as the floor penetrations on our plumbing are in line with the drain. Using a tubing bender I chose 45 degree bends which caused a little bunching and wrinkling on the inside of the bend. It also caused a little cracking on the outside of the bends. A pair of 30 degree bends might not have caused those issues. The other problem was at the floor line connection. Our supply is 1/2" male pipe thread. The nuts and rubber seals for this connection are fine but the thin brass washer included for this connection would not stand up to the load. it is too thin and too narrow. You should provide a better washer.